cht – INVESTEGATE

Prusa NEXTRUDER nozzle flow comparsation

Leave a Comment / Allgemein, Prusa, Prusa XL / By INVESTEGATE

Is the silicon carbide from Phaetus a good and inexpensive alternative to the E3D Nextruder nozzles? We compared three different nozzles to determine the maximum flow rate in mm3/s. We didn’t expect the values to be so close. Of course, even more can be achieved by increasing the temperature. A comparison with the Nextruder CHT

Prusa NEXTRUDER nozzle flow comparsation Read More »

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

How to fix your squashed Nextruder Nozzle

Some people may already be familiar with this problem. You mount your Nextruder nozzle and screw it on a bit too tightly. This squashes the tube at the attachment point, which can lead to errors and blockages. According to Prusa, the fastening screw can be tightened to a maximum of 0.2-0.3nm. If you don’t have

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals