firmware – INVESTEGATE

Custom Firmware v1.0 for Original Prusa MK3.5 / MK3.5S

Leave a Comment / Allgemein, Prusa / By INVESTEGATE

This Custom Firmware v1.0 is an unofficial firmware release for the Original Prusa MK3.5 and MK3.5S, based on Prusa-Firmware-Buddy v6.5.3. It adds experimental tuning options for LGX / LGX Shortcut FF and similar third-party extruder setups, while keeping the stock Prusa behavior as close as possible.

Custom Firmware v1.0 for Original Prusa MK3.5 / MK3.5S Read More »

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

Flashing Custom Firmware on the Prusa XL

Leave a Comment / Allgemein, Prusa, Prusa XL / By INVESTEGATE

Step-by-step guide to flashing custom firmware on the Prusa XL – including bootloader, BBF builds, Klipper and common troubleshooting tips.

Flashing Custom Firmware on the Prusa XL Read More »

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

Is Prusa now really Open Source again?

Leave a Comment / Allgemein, Prusa / By INVESTEGATE

Is Prusa finally open source again? Check the current licensing situation, what’s changed and what it means for users and developers.

Is Prusa now really Open Source again? Read More »

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals