mk4 – INVESTEGATE

Is Prusa now really Open Source again?

Many people didn’t even notice. Since the new Buddy Board was released with the new Prusa 3D printers, it was no longer possible to flash these boards with custom firmware without voiding the warranty. This affected the Prusa MK3.5, MK3.9, MK4, and the Prusa XL. Fortunately, Prusa has changed its mind, and now the broken

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

Prusa NEXTRUDER nozzle flow comparsation

Leave a Comment / Allgemein, Prusa, Prusa XL / By INVESTEGATE

Is the silicon carbide from Phaetus a good and inexpensive alternative to the E3D Nextruder nozzles? We compared three different nozzles to determine the maximum flow rate in mm3/s. We didn’t expect the values to be so close. Of course, even more can be achieved by increasing the temperature. A comparison with the Nextruder CHT

Prusa NEXTRUDER nozzle flow comparsation Read More »

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals