shortcut

mk3.5s custom firmware

Custom Firmware v1.0 for Original Prusa MK3.5 / MK3.5S

Leave a Comment / Allgemein, Prusa / By

This Custom Firmware v1.0 is an unofficial firmware release for the Original Prusa MK3.5 and MK3.5S, based on Prusa-Firmware-Buddy v6.5.3. It adds experimental tuning options for LGX / LGX Shortcut FF and similar third-party extruder setups, while keeping the stock Prusa behavior as close as possible.

Custom Firmware v1.0 for Original Prusa MK3.5 / MK3.5S Read More »

All Prusa XL technical articles are collected here: Prusa XL Technical Series

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

All Prusa XL technical articles are collected here: Prusa XL Technical Series

IMG_0835-scaled

Prusa i3 MK3.5s with Bondtech LGX Shortcut

3 Comments / Allgemein, Prusa / By

Prusa i3 MK3.5s with Bondtech LGX Shortcut: setup, benefits and hands-on experience with feeding performance improvements.

Prusa i3 MK3.5s with Bondtech LGX Shortcut Read More »

All Prusa XL technical articles are collected here: Prusa XL Technical Series

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

All Prusa XL technical articles are collected here: Prusa XL Technical Series

Nach oben scrollen