warranty – INVESTEGATE

Is Prusa now really Open Source again?

Many people didn’t even notice. Since the new Buddy Board was released with the new Prusa 3D printers, it was no longer possible to flash these boards with custom firmware without voiding the warranty. This affected the Prusa MK3.5, MK3.9, MK4, and the Prusa XL. Fortunately, Prusa has changed its mind, and now the broken

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals

Complaint about my Prusa XL – My experience with Prusa Support

Leave a Comment / Allgemein, Prusa, Prusa XL / By INVESTEGATE

I pre-ordered the Prusa XL with 2 toolheads on the first day of its launch. Almost two years later, I was one of the first to receive the printer. Introduction In this article, I’d like to share my experiences with the Prusa XL. Even though I’ll point out some issues below, I consider the Prusa

Complaint about my Prusa XL – My experience with Prusa Support Read More »

This article is part of the Prusa XL Technical Series on INVESTEGATE.de

All guides assume that the Prusa XL Fundamentals are correct.
If not, start here: Prusa XL Basics – Technical Fundamentals